How dig your own well?

Use the well point method. Start a pilot hole. Using a post hole digger or shovel, dig a hole two feet deep. Install your well point. Well points are generally made of steel or any other hard metal so that they can withstand being driven deep into the ground. Begin driving the well point. Add each extension of pipe. Click to see full answer. Also, where can I dig a water well?Hacking at the ground with a pick and shovel is one way to dig a well. If the ground is soft and the water table is shallow,then dug wells can work. Historically, dug wells were excavated by hand shovel to below the water table until incoming water exceeded the digger’s bailing rate.Likewise, can you deepen an existing well? Well Deepening: Reentering an existing well and drilling to a deeper reservoir. Well deepening is re-drilling into an already existing well in order to find a deeper more productive reservoir. Sometimes a previously unproductive well can be deepened in order to reach a location with higher flow and temperature. Similarly one may ask, how much does it cost to put in a well? Drilling a well costs $5,500 for an average depth of 150 feet. Most projects range between $1,500 and $12,000. Expect to pay between $15 and $30 per foot of depth, or up to $50 for difficult terrain. Digging might be enough for shallow depths, ranging between $10 and $25 per square foot.How many years does a water well last?Water wells use pumps that are used to drive water from the ground to your home. These pumps determine the lifespan of your well. Submersible pumps that are commonly used in many wells usually last from eight years to ten years. With proper maintenance and care, the lifespan can be increased to fifteen years.