How do I adjust my rear windshield wiper?

Steps Turn the windshield wiper switch off. Follow the wiper arm away from the wiper blade to its base. Pry up the plastic dust cap covering the nut. Select a socket sized to fit the hex nut. Set the ratchet to allow it to tighten the nut. Tighten the nut. Test the wipers. Click to see full answer. Similarly, how do I fix my rear windshield wiper? How to Replace a Rear Windshield Wiper Lift the wiper arm away from the rear window until it locks in an outward position. Remove the blade by turning it at a right angle to the wiper blade arm. Slide the new blade into the wiper arm, making sure that it properly locks into place. Return the wiper arm carefully to the rear window. One may also ask, how do I adjust my wiper park position? Use a socket wrench to remove the nut located at the center of the wiper motor. This nut connects the arm linkage to the motor. Turn the wipers on, then back off, so the motor completes a full cycle and returns to the correct park position. The blades will not move since the linkage has been disconnected. Herein, can windshield wipers be adjusted? Adjusting the wiper blade alignment is even simpler and has fewer steps. You just need to grab your pliers and bend your wiper arms back into the right position. It is actually good to use two sets of pliers for this job. You can hold the wiper arm in place with one set and twist with another.How do you adjust the tension on a rear windshield wiper arm? Turn your car ignition to the “On” position, without starting the engine. Turn on the windshield wipers and then stop them in the “Park” position, the lowest part of the wipe pattern. Manually lift one of the wiper blades off the windshield, then release it, letting it hit the glass.