How do I put a hole in a door hinge?

To cut hinge mortises on a door: Screw the hinge to the door or jamb. Score around the outline of the hinge with a utility knife. Remove the hinge from the door or jamb. Position the chisel on the scored line with the chisel perpendicular to the door or jamb and the bevel side of the chisel facing toward the mortise. Click to see full answer. Simply so, how do you fix a stripped door hinge hole?Spread carpenter’s glue onto a 3/8-inch-diameter x 1-inch-long wood dowel and tap it into the hole until it’s flush with the jamb. Bore out and plug each of the remaining stripped screw holes the same way. Wait at least an hour. Then reposition the hinge leaf and bore 1/8-inch-diameter pilot holes.Also Know, how do you fit a door hinge to a kitchen unit? Fit The Hinges To The New Door To fit the new door, start by fitting the hinges to the door. Place the hinge into the hinge hole on the back of the door, making sure that the hinges are fitted level, so that the arm of the hinge is at a right-angle to the edge of the door. Next drill two 2mm dia pilot holes. Also to know, how do you bore holes in cabinet hinges? To drill the flat-bottomed hole for the cup, you’ll need a 35-millimeter Forstner bit. Mark a depth line ½ inch up the side of the bit, position it on the center point, and bore into the door until you hit the line. Blow out the shavings and test-fit the cup to make sure the hinge flanges touch the door surface.How do you set up a hinge jig? Setting-up Once the router has been fitted with a cutter and guide bush, position the door with the hanging edge uppermost. Then, adjust the two edge stops to the width of the hinge leaf against the scribed line on the jig and place the Hinge Jig on the hanging edge of the door.