How do I remove a mass air flow sensor?

How to Remove a Mass Air Flow Sensor Locate the air intake and air box. Remove the air box cover and pull the air filter out. Loosen the hose clamps on the intake tube with a screwdriver and remove the air intake tube from the air box. Click to see full answer. Simply so, can I remove my mass airflow sensor?Well, the answer to that is no. If you disconnect the mass airflow sensor, then the car should keep running and still be able to start normally. This is because the computer in the car if it does not receive a reading from the mass airflow sensor, will estimate and supply a number that it thinks it is supposed to have.Likewise, what are the symptoms of a bad mass air flow sensor? 3 Symptoms of a Bad Mass Air Flow Sensor Your Car Hesitates or Suddenly Jerks Forward While Accelerating. A bad MAF sensor can cause your vehicle to experience poor drivability issues such as engine stalling, jerking or hesitation during acceleration. Your Air Fuel Ratio is Too Rich. Your Air Fuel Ratio is Too Lean. Beside this, should you clean or replace mass air flow sensor? This causes starting, idling and acceleration problems, as well as poor gas mileage. Carmakers like Ford and Chevrolet recommend that you replace the MAF sensor ($300) at that point. But if you clean your car’s MAF sensor regularly, you can avoid that $300 repair and keep your engine running at top efficiency.Why would a car run better with the mass air flow sensor unplugged?Because either the sensor is reporting incorrect air amount and or air temperature to the ECU. By disconnecting the sensor the ECU switches to limp mode and the car may idle better . Some MAF sensor wires can be cleaned and some cannot as the wires are not easily accessible .