How do I reset my Taylor Scale?
The following reset procedure is used when the scale shows an err2, err, 0.0, inaccurate weight, or some other unusual error. Remove the battery from the scale. Sit the scale on a hard surface floor. Step up onto the scale, stand still for about 5 seconds and step off the scale. Re-install your battery. Click…
The following reset procedure is used when the scale shows an err2, err, 0.0, inaccurate weight, or some other unusual error. Remove the battery from the scale. Sit the scale on a hard surface floor. Step up onto the scale, stand still for about 5 seconds and step off the scale. Re-install your battery. Click to see full answer. In respect to this, why is my Taylor scale not working?If you’ve had your scale for a while and it no longer is working, check that it is positioned on a stable, level surface. Using the scale on a location with an uneven floor surface can cause the scale to register an instability error on the display or provide an inaccurate weight.Additionally, why is my digital scale not working? Check the Batteries Battery problems are often the cause behind digital scale display and function issues. Carefully open the battery compartment and remove the batteries. Use a small, clean paintbrush or cotton swab to sweep the compartment free of dust or debris that might interfere with the battery connection. Also Know, how do you program a Taylor scale? The easiest way to program the scales is to pull the manual up for the scale and follow the directions. The procedure does vary according to the scale. In general the procedure is to tap the power or set button until it brings up the height and then hit the arrow keys until you get to the correct height.How do you calibrate a small digital scale? Steps Place the scale on a sturdy, level surface. Place one or two computer mouse pads on the table’s surface. Place your scale on the mousepad and power on the unit. Press the “Zero” or “Tare” button on your scale. Verify that your scale is set to “calibration” mode.
