How do you change a thermal fuse on a Roper dryer?
Instructions Shut off the power. Unplug the dryer to disconnect electrical power. Remove the back panel. Move the dryer forward and use a 1/4-inch nut driver to remove the screws from the back panel. Remove the fuse. Install the new thermal fuse. Reattach the back panel. Plug in the dryer. Clean the exhaust vent. Click…
Instructions Shut off the power. Unplug the dryer to disconnect electrical power. Remove the back panel. Move the dryer forward and use a 1/4-inch nut driver to remove the screws from the back panel. Remove the fuse. Install the new thermal fuse. Reattach the back panel. Plug in the dryer. Clean the exhaust vent. Click to see full answer. Likewise, where is the thermal fuse located on a Roper dryer?Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system.Likewise, will the dryer run if the thermal fuse is blown? The thermal fuse (also called a thermal cutoff) on a dryer is a safety that will blow if the dryer has overheated. When the fuse blows it can cause the dryer to run but not heat, or to not run at all. If you have a bad thermal fuse, make sure address why the dryer was overheating. how do I know if my thermal fuse is blown? Touch the left multimeter lead to the left side of the thermal fuse; touch the right multimeter lead to the right side of the fuse. Keep an eye on the multimeter needle; a needle that fails to move indicates a blown thermal fuse. If this is the case, don’t fret: thermal fuse replacement is a simple task.How do I reset my thermal fuse? How to Reset a Thermal Fuse Unplug the clothes dryer’s power cord from the wall outlet. Swing the front panel out towards you so that you can look into the compartment. Aim a flashlight at the flat-can-like component to locate the blown thermal fuse.
