How do you cut an Aquapanel?
Score one side with a sharp knife, cutting through the mesh. Snap the board along the score, then cut through mesh on other side. Smooth any rough areas caused by scoring with a rasp. Knauf Aquapanel Interior should be screwed to the framework at maximum 250mm centres, with screws 15mm from the board edge.Click to…
Score one side with a sharp knife, cutting through the mesh. Snap the board along the score, then cut through mesh on other side. Smooth any rough areas caused by scoring with a rasp. Knauf Aquapanel Interior should be screwed to the framework at maximum 250mm centres, with screws 15mm from the board edge.Click to see full answer. Correspondingly, what is the best tool to cut cement board?The simplest way to cut cement backer board is to score the surface and snap the sheet along the scored line, similar to the way you’d cut drywall. In fact, you can use a drywall utility knife to score backer board, but a better option is a carbide-tipped scoring tool.Also, can you tile directly onto Aquapanel? EN 12004/12002), then embed Knauf Aquapanel Joint Tape. Allow for the adhesive in the joints to dry. Lay tiles directly onto the Knauf Aquapanel Floor Tile Underlay using a complete bed of flexible tile adhesive (class C2/S1 acc. For more information refer to Knauf Drywall Technical Services. Consequently, do you need to seal Aquapanel before tiling? Aquapanel boards do not have to be sealed before tiling but it is important to make sure that the joints between the boards are well sealed. Aquapanel sell a joint adhesive especially for this job although a good quality silicon does just as well.Can you skim Aquaboard?Knauf Aquapanel has its own marble based Aquapanel Interior Skim (ready mixed plaster that is specifically designed for damp areas – mainly targeted for swimming pool areas), but can be skimmed with gypsum plaster (as a cement board the initial suction will be high!
