How do you hang drywall on uneven walls?

Applying Drywall Glue Apply a 1/4-inch bead of drywall glue to the studs where the edges of drywall panels will meet. The glue acts as a gentle shim to hold the panels out slightly from the studs. Position a drywall panel on the wall, and insert drywall screws along the edge studs at least 16 inches apart. Click to see full answer. Then, how do you fix uneven walls? Using Paint Effects to Disguise an Uneven Wall – Repair the biggest cracks and imperfections using filler or plaster. – Sand the wall using a block and paper or an electric sander. – When the wall is smooth, wash it down carefully and leave to dry. – If the plaster is old and very porous, apply a primer. Furthermore, how do you Drywall an uneven ceiling? If it’s an obvious part of the ceiling, try for 1/16″. Get a long straightedge and a pile of drywall shims. High joists are pretty easy: add shims to bring them down to flat with the others. Low joists require you to build up the adjacent joists gradually over a few joists to meet that 1/8″ (or 1/16″). Herein, what is behind the drywall? Wires. Electrical cables are usually behind drywall, either running horizontally through holes in the studs or stapled vertically up the sides of studs. Outlet cables tend to be about 12 inches high. Light switches are around 48 inches high, so expect to see electric cables around that area.How much wall can plumb out?Walls shall not be out of plumb greater than 1 1/2 inches in 8 feet when measured from the base to the top of the wall. Wood framed walls shall not be more than 3/8 inch out of plumb for every 32 inches in any vertical measurement. All interior and exterior walls have slight variances in their finished surfaces.