How do you ignite state select water heater?

How to Light the Pilot on a State Select Water Heater With Squeeze Metal Cover Gently And Pull To Remove. [02:15] Press The Ignition Switch About Once Per Second. [02:48] If The Pilot Does Not Light Within 30 Seconds. [02:54] Wait Another 10 Minutes Before Trying Again. [03:01] Release The Gas Control Knob And The Pilot Will Stay Lit. [03:09] Set The Theremostat Knob To The Desired Temperature. [03:34] Click to see full answer. In respect to this, how do you reset a state select water heater?Locate the large red button marked “Reset” at the center of your State water heater’s control circuit panel. Firmly press the “Reset” button to manually reset your water heater. Once your water heater has been reset, it may take between 12 and 24 hours for your water heater to resume normal operation.Also Know, how do I turn on my electric pilot light? How to Relight an Automatic Pilot Light Set the thermostat on your furnace to its lowest setting. Remove the access panel covering the gas control knob. Turn the gas control knob to the OFF position. Turn the gas control knob or knobs to the ON position. Turn the electrical power to the furnace back on. Likewise, how do you ignite a water heater? How to Light a Water Heater Pilot Light Open the door/cover over the pilot light access. Use a flashlight or a headlamp to find the burner inside. Turn the gas knob to “Pilot,” press and hold it down. While still holding the gas down, light that pilot. When the flame ignites, continue to hold the gas knob or button down for a full minute. Do all water heaters have a reset button?The water heater reset button is the red button located on the water heater itself (just above the thermostat). Some water heaters may have two reset buttons-one for each thermostat. To access the reset button, you may have to remove the metal plate covering the thermostat that’s held in place by screws.