How do you install cedar tongue and groove siding?
Installing Tongue & Groove Siding In horizontal application, start at the bottom and work up with the groove edges facing downwards. Siding up to 6 inches wide can be blind nailed with one siding nail per bearing toe-nailed through the base of each tongue. Wider siding should be face nailed using two nails per piece.Click…
Installing Tongue & Groove Siding In horizontal application, start at the bottom and work up with the groove edges facing downwards. Siding up to 6 inches wide can be blind nailed with one siding nail per bearing toe-nailed through the base of each tongue. Wider siding should be face nailed using two nails per piece.Click to see full answer. Subsequently, one may also ask, what nails should I use for cedar siding?Use Hot-Dipped Galvanized, Aluminum or Stainless Steel. Hot-Dipped galvanized, aluminum and stainless steel nails are all corrosion-resistant and all can be used to nail Western Red Cedar.Additionally, do you nail through the tongue or groove? The traditional method of nailing hardwood tongue and groove flooring is to drive nails at an angle through the tongue of a plank and into the subfloor below, but this is time-consuming and can result in poorly inserted nails. Beside above, how do you attach cedar siding? Bevel siding should be face nailed to studs with 1-1/4 inch penetration into solid wood using one nail per piece spaced at a maximum of 24 inches on center. Place nail just above the overlap. Take care not to nail through the overlap of two pieces.How much do you overlap cedar siding?If the overlap of the two pieces of siding is 1 1/4 inches, then the nail for a piece of siding should be 1 3/8 inches above the bottom edge. This nail spacing allows each piece of siding to float and move easily.
