How do you reinforce transom?
Be sure both the plywood and transom are clean and dust-free. Prepare the resin. Immediately wrap each piece of plywood with resin treated fiberglass cloth, and install the sticky mess on both sides of the transom and bolt it all into place (with the nuts to the inside). Allow time to cure.Click to see full…
Be sure both the plywood and transom are clean and dust-free. Prepare the resin. Immediately wrap each piece of plywood with resin treated fiberglass cloth, and install the sticky mess on both sides of the transom and bolt it all into place (with the nuts to the inside). Allow time to cure.Click to see full answer. Consequently, how do you fix a transom?Remove all traces of the old plywood then sand and clean with 80-grit sandpaper. Be sure and sand the edges where the inner layers of fiberglass attach to the hull, it will make bonding the new transom in place much easier. Vacuum up the dust and wipe down the fiberglass with acetone. how do I know if my boat transom is rotten? There should actually be 0 flex to teh transom. If there is no motor, then poke the holes in the transom with a screw driver to see if the wood there is soft. Also, a knock on the transom with your hand or a rubber mallet. Subsequently, question is, how many layers of fiberglass do I need for boat stringers? Probably 3 layers fine if you glass or bond the floors to top of the stringers.How do you reinforce a fiberglass transom?Rough up the edges of the outer fiberglass skin you removed from the transom with the palm sander. Apply a heavy coat of epoxy to the last sheet of plywood you used to fill the transom void, and replace the outer fiberglass skin of the transom, using wood screws around the edges to attach the fiberglass to the plywood.
