How do you remove a prop from a Mercury outboard?
VIDEOClick to see full answer. Consequently, can you over tighten a prop nut?Hard to believe you would be over-tightening the prop nut as this spec is often around 50 ft lbs. Hand tightened or otherwise too loose may allow the prop to slam back in reverse with great force against the nut and possibly shear…
VIDEOClick to see full answer. Consequently, can you over tighten a prop nut?Hard to believe you would be over-tightening the prop nut as this spec is often around 50 ft lbs. Hand tightened or otherwise too loose may allow the prop to slam back in reverse with great force against the nut and possibly shear the securing cotter pin with potential eventual loss of the prop.Also Know, how do you know if your prop is slipping? To tell if your hub has spun, mark a line on the back of the prop hub with lipstick. You can also score your mark using a file. With the mark in place over the inner and outer hub, it’s a simple matter to pull the prop and see if the mark has broken in two. If it has, you have spun a hub. Herein, how tight should prop be? The prop nut should be pretty darn tight. I dont use a torque wrench on mine but I crank it down good. Use a block of wood between the propeller blade and lower unit to hold the prop from turning while you tighten it.How do you get a stuck prop out of a outboard motor? How To Remove an Inboard Boat Propeller Leave the Nut On. With a block of wood preventing the prop from spinning, remove the cotter pin and loosen both nuts. Try a Grab Grasp the propeller firmly by the root of two blades. Give an even pull. Prop Knocker. You may need to turn the rudder slightly to provide clearance. Prop Puller.
