How do you remove a Symmons tub spout?

Step 1: Remove any caulking around the wall end of the tub spout with a putty knife or razor. Step 2: Unscrew the tub spout in a counterclockwise rotation until the tub spout is removed off of the brass adapter. Step 3: Use a 1/8″ hex/Allen wrench and un tighten the Allen screw counterclockwise.Click to see full answer. In respect to this, how do you fix a tub spout?Replacing a slip-on spout is easy: Just loosen the setscrew (usually with a hex wrench) and pull the spout off the copper pipe that protrudes from the wall. Twist the spout as you pull and be gentle so you don’t loosen any pipe connections inside the wall. Then slide on the new spout and tighten the setscrew.Subsequently, question is, how does a tub spout diverter work? Basically, the main water pipe running to the bathroom starts at the tub faucet and then runs vertically to connect the same waterway to the showerhead above the faucet. When the faucet is turned on, water rushes to the first port and drains into the tub. Just so, how do you fix a loose tub spout? How to Fix a Loose Tub Faucet Spout Step 1 – Locating the Set Screw. Look beneath the tub spout to check if there exists any set screw. Step 2 – Open the Tub Spout. Using the screwdriver, place its tip inside the end of the bathtub spout. Step 3 – In Case Of Twist-on Spout. Step 4 – Get the Right Faucet Spout. Step 5 – Installing New Faucet Spout. What causes a leaky bathtub faucet?The most common cause of a leaky tub faucet is a worn out washer. You can save yourself a ton of money on your water bill by replacing the old washer with a new one. Use these steps from Newcomb and Company to replace your worn out washer and stop your faucet from leaking!