How do you remove a tub skirt?

Find a spot to insert a flat-head screwdriver near the bottom end of the skirt. Pry the bottom of the skirt away from the tub, using care to avoid scratching the bathroom floor. The top of the skirt unhooks from underneath the top tub lip as you pull the bottom. Remove the skirt from the tub completely.Click to see full answer. Similarly, it is asked, how do I remove my tub access panel? How to Take Off the Front Panel of a Jetted Tub Turn off the jets and drain the tub of all water. Turn off the main breaker of your electrical box to ensure that no power is going to the tub before performing any repair. Place a large suction cup firmly against the front access panel, put your finger inside the attached ring and pull toward you to remove the panel. Also, how do you install a tub apron? Install the apron by sliding the upper edge of the apron under the edge of the bathtub and centre the apron between the two walls. Maintain the apron in position and insert the plastic thumb screws through the holes under the lower edge of the apron and in the hardware (Fig. 7.1). Likewise, how do I remove a cultured marble bathtub? How to Remove a Cultured Marble Bathtub Surround Lay tarps in a bathtub, over the floor and fixtures in the bathroom. Slice through the caulking between the cultured marble panels and at the edges with a utility knife. Put on safety goggles, work gloves and a dust mask. Wedge a thin pry bar under the edge of the cultured marble tub surround. How do you remove a drain from a bathtub? Steps Unscrew a foot plug drain’s stopper. Put on your rubber gloves and grasp the center stopper. Pop out a lift-and-turn drain’s stopper. Grasp the stopper and pull up on it. Remove the faceplate of a trip lever drain. Set your tub to the “open” position, if it has a visible stopper.