How do you remove wires from tombstones?

Insert the paper clip into the damaged tombstone next to one of the two tombstone wires. The paper clip opens the tension spring connector inside the tombstone and allows you to pull out the wire. Repeat this for the remaining wire attached to the tombstone.Click to see full answer. Furthermore, how do you remove a fluorescent light holder? How to Replace a Fluorescent Light Socket First make sure the problem the socket needs replacing. It might be that the bulb is about to die. Turn off the power to the fluorescent light. Take out the bulbs from the fixture. Remove the socket so you can examine the wiring. Put the wires from the light into the new socket’s terminal slots. Additionally, are t8 and t12 sockets the same? T12 primarily run off a magnetic ballasts and T8 bulbs operate on electronic ballasts. But most people have them operating on a magnetic ballast. Even though the fluorescent light socket is exactly the same for both of them, they cannot operate on the same ballast. Thereof, are t12 tombstones shunted? Non-Shunted Rapid Start Tombstones like this are needed. T8 fixtures must have the input side sockets changed to T12 sockets of the “Non-Shunted Rapid Start” type, as T8 sockets have a circular conductor that will not allow them to properly separate the line and the neutral sides of the circuit.Can you replace t12 fluorescent tubes with LED?Install a direct wire or ballast-bypass linear LED lamp. Right now, a ballast-bypass is our top LED replacement option for T12 fluorescent tubes. Ballast-bypass LEDs work straight off the line voltage flowing directly to the sockets, requiring you to remove the original fluorescent ballast.