How do you reset the flashing light on a Whirlpool dishwasher?

How to Reset the Blinking Light on a Whirlpool Dishwasher Locate the display on your Whirlpool dishwasher, and confirm the light is still blinking. Press the “Heated Dry” button, then quickly press the “Normal” button. Press the “Heated Dry” button again, and press the “Normal” button again to enter the diagnostic mode. Click to see full answer. Likewise, people ask, how do I fix the flashing light on my Whirlpool dishwasher? Whirlpool Dishwasher Error Codes – Lights Blinking Flashing 1 – Turn the dishwasher on. 2 – Press the rinse cycle button. 3 – Turn the dishwasher back off. 4 – Hold down the start button while you turn the dishwasher back to on. 5 – When the light starts flashing immediately let go of the start button. 6 – Press the start button one time and shut the dishwasher door. Also, why is my Whirlpool dishwasher blinking? Whirlpool Dishwasher lights flashing or blinking. The heating element heats up the water to operating temperature. If the water doesn’t reach the proper temperature after a set amount of time, a light on the control panel might start flashing. The drain pump uses an impeller to force water through the drain hose. Besides, how do you reset a Whirlpool dishwasher? To reset it, you will have to have the door open. It can not be latched. Press “Heated Dry,” “Normal,” “Heated Dry,” “Normal” within three seconds of the first pressed button. Now close the door, this should reset your dishwasher.Why are the lights on my dishwasher flashing?Blinking “Start/Reset” light: Indicates that the dishwasher has been reset and is in the process of turning off. Other blinking lights or beeping sounds: May indicate a problem with the dishwasher caused by power surges. Try pressing the “Start/Reset” pad to reset the dishwasher and wait 2 minutes.