How do you strap a hot water heater?
Wrap the heavy-gauge metal strapping 1-1/2 times around the tank. Start by placing the strapping at the back of the tank. Bring it to the front and then take it back to the wall. Secure this strapping to the wall studs or the wood block using several 1/4-inch x 3-inch or longer lag screws with…
Wrap the heavy-gauge metal strapping 1-1/2 times around the tank. Start by placing the strapping at the back of the tank. Bring it to the front and then take it back to the wall. Secure this strapping to the wall studs or the wood block using several 1/4-inch x 3-inch or longer lag screws with oversized washers.Click to see full answer. Also asked, do hot water heaters need to be strapped?All water heaters must be strapped in at least two locations; the upper one-third of the unit and the lower one-third. The lower strap must be a minimum of 4″ above the water heater control unit. The required clearances from a wall to the heater as stated on the unit nameplate are critical.Likewise, how do you strap a water heater code in California? California Plumbing Code Section 507.2 requires that all water heaters shall be supported and strapped to prevent movement during an earthquake. Two metal straps, not less than 22 gauge, nor less than 5/8-inch wide shall be used. Keeping this in consideration, what states require strapped water heaters? Both Oregon and Washington states have laws requiring double-strapping of water heaters in homes, with some specific provisions and exceptions.Does Oregon require water heaters to be double strapped?If a water heater has already been installed and it appears to be unsafe or unstable, straps will be required. Oregon: Straps are required on the upper one-third and lower one-third of the water heater.
