How do you strip spindles?
Spray sanding sealer on the spindle either with an air gun or an aerosol can. Let it dry, then sand lightly with 220-grit sandpaper. Apply two or three clear finish coats by spraying, sanding each coat lightly with 220 or finer paper after it dries and before applying the next.Click to see full answer. Hereof,…
Spray sanding sealer on the spindle either with an air gun or an aerosol can. Let it dry, then sand lightly with 220-grit sandpaper. Apply two or three clear finish coats by spraying, sanding each coat lightly with 220 or finer paper after it dries and before applying the next.Click to see full answer. Hereof, how do you remove varnish from spindles?You can use a stiff-bristled scrub brush to remove varnish from fancy, curved details. Some of the stain may linger after scraping. To remove it, dampen a soft, fine-grade steel-wool pad with more paint stripper and rub it against the wood, following the wood grain, then wipe off the softened stain with a rag.One may also ask, does vinegar remove varnish? As proof of its power, vinegar can tackle even the toughest of substances: varnish. One blogger used a 50-50 mix of warm water and white vinegar to strip the varnish from his hardwood floors. While it’s tough on stains, vinegar is gentle on the skin. Moreover, what is the best way to sand spindles? The proper way to sand spindles is with two grades of sandpaper — from heavy to light. Fold a sheet of 100-grit sandpaper three times. Revolve the spindle back and forth, twisting it while you encircle it with the sandpaper. Slide the cylinder of sandpaper down or up the spindle, overlapping the first area by 1 inch. What is the best varnish remover? Methylene Chloride Stripper You’ll seldom have to resort to the strongest stripper, which is lye-based and caustic, to remove varnish, but heavy coats of polyurethane or spar varnish require a strong chemical.
