How do you test a flammable vapor sensor?
Flammable Vapor Sensor Location / Testing sensor from it’s bracket on the base ring of the water heater and disconnect both wires to the sensor. Take a resistance reading between the two wiring terminals of the FV sensor and note the resistance value.Click to see full answer. Likewise, how does flammable vapor sensor work?The sensor…
Flammable Vapor Sensor Location / Testing sensor from it’s bracket on the base ring of the water heater and disconnect both wires to the sensor. Take a resistance reading between the two wiring terminals of the FV sensor and note the resistance value.Click to see full answer. Likewise, how does flammable vapor sensor work?The sensor is required to detect flammable vapors in less than a minute after a spill enabling the gas valve control module to prevent the supply of gas and burner ignition. It is a passive device that requires no power and continually senses for vapors.Likewise, how do I reset my state select water heater? Locate the large red button marked “Reset” at the center of your State water heater’s control circuit panel. Firmly press the “Reset” button to manually reset your water heater. Once your water heater has been reset, it may take between 12 and 24 hours for your water heater to resume normal operation. Considering this, where is the flammable vapor sensor located? The FV sensor is located on front of many water heaters today. The sensor will trip if it senses gasoline vapors in the air. It does not respond to other types of flammable vapors.How do I reset my Rheem water heater?Turn the water heater’s gas valve switch to the “OFF” position, wait for a few seconds and then flip the switch to the “ON” position to reset the system.
