How do you tighten a Black and Decker circular saw?
2 Press down on the saw’s arbor-lock button and rotate the blade until the locking mechanism engages. 3 Use the blade wrench to remove the arbor nut holding the blade in place. To loosen the nut, turn the wrench in the same direction as the blade cuts. 4 Retract the saw’s upper blade guard and…
2 Press down on the saw’s arbor-lock button and rotate the blade until the locking mechanism engages. 3 Use the blade wrench to remove the arbor nut holding the blade in place. To loosen the nut, turn the wrench in the same direction as the blade cuts. 4 Retract the saw’s upper blade guard and remove the old blade.Click to see full answer. Besides, how do you tighten a circular saw?In general, the blades on right-handed circular saws turn counterclockwise, so you’d tighten the bolt clockwise; the blades on left-handed circular saws turn clockwise, so you’d tighten the bolt counterclockwise. Hold the outer flange (rim) of the nut with a wrench to keep it from turning.Likewise, why does my circular saw blade stop? If your hand is asserting a sideways pressure that will cause binding and the saw will stop. Even a slight sideways pressure combined with dirty/dull blade will cause stoppage. When I first starting using my circular saw, 80% of the time I forgot to adjust the depth of cut, making it work harder than it needed to. Also to know, how do you adjust the depth on a circular saw? Determine the blade depth by unplugging the saw and holding it alongside your board with the blade guard retracted. Then loosen the depth-adjusting lever or knob and pivot the saw’s base until the blade extends about 1/4 to 1/2 in. below the board. Tighten the lever or knob and you’re ready to saw.What does resaw mean?A resaw is a large band saw optimized for cutting timber along the grain to reduce larger sections into smaller sections or veneers. Resawing veneers requires a wide blade – commonly 2 to 3 inches (52–78 mm) – with a small kerf to minimize waste.
