What happens if you reverse line and load light switch?

Here’s what happens when somebody wires a GFCI receptacle with the load and line wires reversed: The GFCI will work, in the sense that you can plug in a hair dryer and the hair dryer will blow hot air. If the load and line wiring gets messed up, a ground fault (radio in the tub) won’t trip the GFCI.Click to see full answer. Regarding this, what happens if you wire a light fixture backwards?This happens when the hot and neutral wires get flipped around at an outlet, or upstream from an outlet. Reversed polarity creates a potential shock hazard, but it’s usually an easy repair. The other wire doesn’t get connected to the earth, and it’s called the ungrounded conductor, or hot wire.One may also ask, what is a load wire on a switch? The load wire connects your light switch to your light fixture. When the switch is “closed”, electricity flows from the light switch to your light fixture, turning on the light. Your existing switch should have been connected to the load wire. It is usually attached to a brass terminal on the previous switch. Considering this, how can you tell the difference between a line and a load wire? Line is the side of the device where the wires from the panel (or other equipment feeding the device) are connected. Load is where any devices that are to be protected by the GFCI device are connected. Most “newer” GFCI devices will not reset if they are not connected probably.Does it matter which wire goes where on a light switch?If your switch has a “LINE” marking, the always hot wire goes to this. The other connection will be “LOAD” where the load (ie light fixture) is wired. The load wire may have red electrical tape on it to differentiate.