Why does my Stihl saw keep stopping?
An engine stalls when it’s getting too much or not enough fuel from the carburetor. Stihl chainsaw carburetors usually have three adjustment screws: one each for idle, low speed and high speed. If the saw is stalling when you pull the throttle trigger or it doesn’t reach its full power, adjust the high-speed (H) screw.Click…
An engine stalls when it’s getting too much or not enough fuel from the carburetor. Stihl chainsaw carburetors usually have three adjustment screws: one each for idle, low speed and high speed. If the saw is stalling when you pull the throttle trigger or it doesn’t reach its full power, adjust the high-speed (H) screw.Click to see full answer. Beside this, why does my chainsaw keeps shutting off?This sticky fuel can clog up the carburetor and cause the chainsaw engine to stall. If the carburetor is clogged, try cleaning it with carburetor cleaner. The fuel filter might be clogged. A clogged fuel filter is often caused by leaving old fuel in the chainsaw.Additionally, what is the H and L on a carburetor? On every saw the “h” means that’s the “high” side adjustment. It regulates how much fuel is being poured into the motor during high rpm’s. The “L” means that’s the “low” side adjustment. Herein, why does my chainsaw dies at full throttle? If your chainsaw engine dies at full throttle, check the following parts: the carburetor, fuel lines, fuel filter, air filter, and muffler. When the carb becomes clogged (which is often the result of old fuel sitting in it over a long period of time, like over the winter), it will not perform this task effectively.Why does my chainsaw bog down when I give it gas? The Job of the Carburetor Without the right amount of air and fuel in the piston cylinder, the 2-cycle engine in a Stihl chain saw runs inefficiently and the saw loses power. When the saw bogs down during cutting, it’s usually the high-speed screw you need to adjust.
