How do I relearn my throttle body?
Accelerator Pedal Release Position Learning Procedure. Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds.Click to see full answer. In this way, does a throttle body…
Accelerator Pedal Release Position Learning Procedure. Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds.Click to see full answer. In this way, does a throttle body need to be programmed?In fact, on some engines a new throttle body needs to be programmed with a factory, or equivalent, scan tool. The technician cannot even clean the carbon out of the throttle body in some cases without setting a “check engine” light.One may also ask, what happens if you disconnect throttle position sensor? If the TPS is not adjusted correctly as evidenced by a 500rpm idle, and hesitation with initial acceleration, unplugging the TPS connector should then cause a correct idle, and a normal acceleration. Correcting the TPS then produced a correct idle, and no code. Furthermore, how do I relearn throttle position? TPS Relearn Process Turn the KOEO, while viewing your scanner, adjust your throttle body set screw until your throttle position is 2% Turn your key to the OFF position, disconnect your scanner. Head out under the hood and unplug your (TPS) and Idle Air Control Valve (IAC) How do I reset my electronic throttle control manually?Turn the ignition switch on and wait 3 seconds. Immediately after the 3 seconds, the accelerator pedal must be pressed and released 5 times within 5 seconds. Wait 7 seconds and fully press the accelerator pedal and hold for approximately 20 seconds until the check engine light stops blinking and stays on.
