How do you edge a driveway with railroad ties?

Place the ties in the trench, butting the ends together and setting them against the far wall of the trench, leaving the 2-inch gap on the driveway side. Drive metal stakes or rebar through the ties and into the ground to anchor them in place.Click to see full answer. Also, how do you line a driveway with railroad ties? How to Use Railroad Cross Ties for Driveway Borders Dig a trench along both sides of your driveway. Drill three holes through each of the railroad ties that you place in the trench using a high-powered drill with a half inch spade bit. Place the railroad ties into the trench in a straight line with all the ties flush together at the ends. Also Know, how do you border a driveway with landscape timbers? How to Border a Driveway With Landscape Timbers Dig a trench next to the driveway using a hand-held hoe or garden spade. Use a 2×4 to stamp the ground flat, level, and compact inside the trench. Lay the first course of the landscape timbers in the trench side by side with the ends pushed closely together. Keeping this in view, what do you use for driveway edging? Tip #2 – Use Belgian block edging to dress up a gravel drive Not only does it contain the gravel but it also can serve as a decorative border. Heath likes to use Belgian block along the edges of the gravel driveways he designs. “When edging a driveway, the jumbo blocks that measure 11” x 8” x 4” are best,” he says.How do you make a railroad tie Bridge? How to Build a Railroad Tie Bridge Determine the exact location for the bridge. Use a shovel to dig an earthen shelf out of each bank. Drive one piece of rebar into each end of each of the dirt shelves. Use the chainsaw to cut two railroad ties to a length equal to the desired width of the bridge.