How do you fix a spring tension rod?

Adjust the tension and length of the rod. Tension rods have two interlocking shafts with a strong spring inside. Place one hand on either side of the spot where the rods connect and twist counterclockwise to lengthen the tension rod or clockwise to shorten it.Click to see full answer. Considering this, how do you fix a tension shower curtain rod?The caps on tension rods are often made of plastic, but even rubber ones are so incompressible that moist, smooth surfaces such as tile or fiberglass can’t hold them. You can fix that by gluing rubber shelf lining material to the ends with strong glue — two-part epoxy or contact cement.Additionally, how do I keep my tension rod from falling down? First, adjust your shower curtain to be a few inches longer than the shower. Hang the shower curtain rod at an angle, with one end several inches higher than you want it. Slowly slide that end down until the rod is hanging straight. The felt pads keep it from sliding futher down the tile wall. Keeping this in consideration, how do you adjust a spring loaded shower rod? Hold the rod in place with the curtain about an inch off the floor, then twist the smaller rod counterclockwise to lengthen it. Keep twisting after both ends have made contact with the walls until the rod has enough tension to stay in place.How do you adjust the tension on a spring curtain rod?Locate the point where the two sections of the tension rod fit together. Tension rods have two interlocking shafts with a strong spring inside. Place one hand on either side of the spot where the rods connect and twist counterclockwise to lengthen the tension rod or clockwise to shorten it.