How do you change the blade on a MK 470 tile saw?

Raise the blade guard to its highest position and retighten the wing nut. Loosen and remove the blade shaft nut (part# H6) & outside blade flanges (part# H5) and set them aside. Place the diamond blade onto the motor shaft against the inside flange.Click to see full answer. Also know, how do you change the blade on a MK tile saw? How to Change the Blade on the MK-370 Tile Saw Unplug the saw’s power cable from the wall outlet. Loosen the wing nut securing the blade guard. Loosen the blade guard retaining knob, then open the blade guard. Insert the shaft wrench onto the shaft, between the blade and body of the saw. Loosen, then remove, the retaining nut using the blade wrench. Also, when should I replace my tile saw blade? If the tray on the wet saw is gliding perfectly straight but your cuts are coming out of plumb, the blade may be warped, damaged or have loosened to the point it cannot be tightened anymore. If you have tried adjusting and tightening the blade but your cuts are still out of plumb, it’s time to replace the blade. Then, how do you change a blade on a brick saw? At the center of the blade will be the retaining bolt for the masonry saw blade. Select the right size wrench and loosen the bolt until you can remove it. Slid off the old blade and set aside. With a brush, clean out all the dust from the saw.How do you change a tile cutter blade? How to Change Tile Cutter Blade Plasplugs Pull the Plasplugs tile cutter’s electrical plug from the wall outlet. Lift the water reservoir’s cover, the tray to the right of the tile cutting blade, off the Plasplugs tile cutter. Turn the cutting blade’s locking nut counterclockwise with an adjustable wrench until the blade shaft releases the nut.